EII – Wet Mix Dust Collector

PART # SYS-050-18300300

• Wet mix dust collector, fabricated from 14 gauge stainless steel which is then thermoset powder coat painted.
• Automatic low water shut down sensor which prevents the unit from operating if water is not set at proper levels.
• Site glass to visually check the water level.
• Manual water level system whereby the customer fills the unit with more water when the water level reaches mark on the site glass.
• Manual drain valve located at the bottom of the separator.
• Initial stainless steel venturi entry for deep penetration into the water, secondary baffles to completely mix the dust particulate with the water whereby no after dry/hepa filter is required.
• A time delay switch is provided to prevent the start of the dust-producing process (sanding tools) until the collector is in complete operation.
• An off delay time switch is provided which allows the system to run for a set amount of time once the sanding has stopped. This ensures all dust in the hose reaches the collector.
• System includes (2) 25’ lightweight anti-static hose with attached airline

*Patent Pending